The special steel company Alleima plays a key role as the Vasa Museum faces its biggest challenge since the salvage. With the wood weakened, the ship needs a new support. Several years of research and advanced testing at the museum have led to a unique collaboration with Alleima to develop an internal, custom-made steel skeleton to support and stabilize the ship. The collaboration entails that Alleima becomes the main partner of the Vasa Museum and the “Support Vasa” project.

Photo::Christopher Nielsen

The Vasa ship is a unique piece of cultural heritage in the world. But despite its impressive size, it is very fragile. Chemical degradation of the wood has caused the hull, which was built from oak in the 1620s, to lose much of its strength. These small movements can have major consequences in the long term. In collaboration with the Vasa Museum, Alleima is providing its world-leading expertise and high-alloyed SAF 2507 super-duplex stainless steel material for a customized inner steel support for the Vasa ship.

“The inner steel support will extend from the keel to the upper deck. It will help support the loads from the deck and deck beams, slowing the downward movement of the hull. Therefore, the inner steel support must be built from a material that is both strong and light. Thanks to Alleima’s special steel, we do not have to drill as many holes in the Vasa’s hull as would otherwise have been necessary. This is incredibly important for us from a preservation perspective. We estimate that we only have to make about half as many holes in the hull as otherwise would have been necessary,” says Magnus Olofsson, project manager of “Support Vasa”.

The inner steel skeleton is built as a truss with tubes. This solution stabilizes the hull, slows down the movements of the ship and distributes the load.

“Alleima’s advanced stainless steel and special alloys are found in the most demanding environments and applications in the world. This material has very high strength, which means that less material is needed for the construction, reducing the weight of the inner steel skeleton. The high corrosion resistance allows the material to come into direct contact with the ship without being affected by the acid that the wood gives off,” says Tom Eriksson, EVP and Head of Strategic Research at Alleima.

“We are proud to contribute to preserving the Vasa ship for the future. This historic project reflects our commitment to innovation and sustainability. The project is unique in both implementation and procurement and shows the power of long-term partnerships between companies and cultural institutions,” says Elja Nordlöf, EVP and Head of Communications at Alleima.

The work to construct Vasa’s inner steel support is due to be completed by 2028, just in time for the ship’s 400th anniversary.

This is not the first time Alleima has collaborated with the Vasa Museum. In 2011, the Vasa Museum and Alleima, then owned by Sandvik, began a long-term research and development collaboration to save the national treasure by replacing the Vasa ship’s more than 5,000 rusty bolts. They were then replaced with specially developed, high-alloy bolts. Thanks to the bolts, the Vasa ship was not only more stable, but also eight tons lighter, which is equivalent to the weight of a full-grown elephant!

Facts about the Vasa ship
On August 10, 1628, the Vasa cast off from its berth below Tre Kronor castle and slowly left the harbor. It was a mighty ship with three masts that could carry ten sails, measured 52 meters from tip to keel, was 69 meters long and weighed 1,200 tons. However, a gust of wind caused the Vasa to capsize, and the water poured in through the open gun ports, causing the Vasa to sink. At least 30 of the 150 or so people on board died. 333 years later, divers found the Vasa at the bottom of the sea, and on April 24, 1961, the ship was salvaged with more than 14,000 loose pieces of wood. Since the salvage, however, work has been carried out step by step to preserve the ship.

Sandviken, January 28, 2025